Fin Tubes - Spiral Tension wound (crimped) fin tubes with Stainless Steel, Copper, CRCA steel crimped fins

Products	Finned Tube Heat Exchangers	Air Heaters	Air Coolers	Oil Coolers
Products	Fin Tubes	Wire Wound (Pin) Fin Tubes	Spiral Crimped Fin Tubes	Wire Inserts (Turbulators)
Services	Process Design of extended surface heat exchangers
Enquire
Homepage

Spiral (Crimped) Tension Wound Fin Tubes

Spiral (Crimped) Fin Tubes with root soldering

We manufacture tension wound spiral crimped fin tubes with or without root soldering with base tube diameters ranging from 12 mm to 100 mm with fin heights between 7 mm to 13 mm. Stainless Steels, Carbon Steels, Copper and Copper Alloy tubes are finned with Stainless Steel, Mild Steel and Copper fins.

Our special finning machines fin tubes in lengths exceeding 6 meters. The strip of metal is continuously tension wound under controlled conditions and if required, simultaneously root soldered. The fin densities are 5 fpi to 12 fpi.

Solders used withstand tube wall temperatures up to 175 deg C. Special solders are used for temperatures between 175 C and 296 C. These fin tubes are not suitable for tube wall temperatures exceeding 300 C.

Spiral (crimped) fin tubes with copper fins

Shown here are Spiral crimped tension wound fin tubes with and without turbulators

TAAM Engineering

1,Neelam Gardens Saubhagya Nagar Nashik Road

Nashik

India 422101

C-27,MIDC Malegaon Sinnar District Nashik

India 422 103

+91 253 6522635

+91 9890945650

Fax: +91 253 2460120

E Mail: mail@taaming.com

Spiral Crimped Fin Tubes

with Base Tubes of:

Stainless Steels

Carbon Steels

Copper

Ad. Brass

Cupro-Nickels

Fins of:

Stainless Steels

Mild Steel Coated without Coating

Copper

Fin Heights:

7 mm to 13 mm

Suitable up to:

296 deg C

in lengths up to:

Any Lengths

Finned Heat Exchangers & Fin Tubes

Finned Tubes For Heat Exchangers

Generally, addition of any metal piece to a heat transfer tube is an extended surface. The addition or attachment of these metal pieces serves a purpose greater than just increase in external area. These pieces are commonly referred to as fins. The fins increase the total heat transfer area, but the process of heat transfer in fin tubes is quite different than simple conduction and convection.

For information about common types of fin tubes please visit our homepage

Finned Heat Exchangers

Heat exchangers for heating or cooling of gases, more commonly air and viscous fluids like lube oil, hydraulic oil, gear oil almost always necessitate use of fin tubes or extended surfaces to enhance the heat transfer film coefficient on gas and oil side. More information about fin tube heat exchangers can be read on our homepage

TAAM engineering - Indian designer & manufacturer of spiral tension wound crimped fin tubes